Station ID Assignment (PGM 110/111/112/113/114) 2-29
Chapter 2: SBX IP Offline PCAdminPro
SBX IP - PC Admin Guide
Auto Forward
to VMIB
ON/OFF ON
Station Port
Block
ON/OFF OFF If this value is set to ON, the station is blocked and it is impossible to
use that station
ISDN Station Attributes (PGM114)
ITEM RANGE DEFAULT REMARK
CLIP LCD
Display
ON/OFF ON This field is determined whether a station displays CLIP
COLP LCD
Display
ON/OFF OFF This field is determined whether a station displays COLP
CLI / Redirect
Display
0-1 0 To Select Original CLI or Redirected CLI.
0: Original CLI, 1: Redirected CLI
CLI MSG Wait ON/OFF OFF An ON setting allows a station to receive CO message wait indications
Ext or CO ATD ATD/EXT EXT To Select EXT (extension number) or CO ATD to make outgoing CLI
or COLP information
Keypad
Facility
KEYPAD/
DTMF
DTMF This field determines whether an ISDN station sends digit in DTMF or
keypad facility after connected
LONG/
SHORT
LONG/
SHORT
SHORT This field determines whether an ISDN station acts in Short passive
mode or in the Long mode.
CPN Type 0-2 0 This field indicates how the CPN IE is filled in SETUP message.
0: Do not sent CPN (Called Party Number) to S0. In this case, all S0
STA of the S port will be ringing.
1: Send station number as CPN
2: Bypass the CPN from the network.
(In options 1 & 2, only one specific STA will be ringing)
Station Attributes III (PGM113)
ITEM RANGE DEFAULT REMARK
To Next Page
Loading...
