System Attributes (PGM 160/161/163) 2-58
Chapter 2: SBX IP Offline PCAdminPro
SBX IP - PC Admin Guide
Clear ACD
Database
after Print
ON/OFF OFF Determines if ACD database initializes
after print-out.
VMIB Prompt
Gain
00-31 08 To control prompt gain level
VM with CLI
Info
ON/OFF OFF If the setting is ON, CLI is added when
Voice Mail information is printed through
RS232 port by SMDI.
ACD Print
Timer Unit
1: HOUR
0: SEC
SEC Determines the unit of ACD Print timer of
Flex Btn 10 (1 hour or 10 seconds)
Set VM SMDI
Type
TYPE II/
TYPE I
TYPE I Set VM SMDI type.
Incoming Toll
Check
ON/OFF OFF Enable or disable the toll check for
incoming calls
No DSS
Indication
ENABLE/
DISABLE
DISABLE Enable or disable the LED of the CO
button while ringing for incoming, transfer
and recalling. It is not applied for direct
ringing such as DID/DISA.
UK Billing
Mode
ON/OFF OFF If this value is set to ON, UK Billing Mode
is applied (UK only).
COS 7 When
Auth Fail
ON/OFF ON If authorization is failed with PGM 227,
COS will be COS 7 or not with this setting.
Auto Fax
Transfer CO
01-36 If Auto FAX CO line is programmed, the
system answers and detects the FAX
calling tone (1100Hz, 0.5sec ON/3sec
OFF repeat tone) from an incoming analog
CO line. The system will route this call to
the last SLT port on BKSU) when tone is
detected within programmed time.
System Attributes II (PGM161)
ITEM RANGE DEFAULT REMARK
To Next Page
Loading...
