System Timers I - III (PGM 180, 181,182) 2-78
Chapter 2: SBX IP Offline PCAdminPro
SBX IP - PC Admin Guide
ACNR Tone Detect Timer 001-300
(3 digits)
030
(sec)
This timer is invoked upon completion of dialing and the
system considers the CO party as busy in the case that
the CPTU cannot detect a valid tone type until this timer
expires.
Automatic CO Release
Timer
020-300
(3 digits)
030
(sec)
An uncompleted CO call will be automatically released
after this timer expires.
CCR Inter-digit Timer 000-255
(3 digits)
030
(100ms)
This field is used for the CCR inter-digit timer in the
DISA/DID CO line. In DID type 2, it is used for the DID
inter-digit timer.
CO Call Drop Warning
Timer
00-99
(2 digits)
10
(sec)
If prepaid money is going to expire during a CO
conversation, give warning tone and after this time the call
will be disconnected.
This timer is also used for Call Restriction, Unsupervised
Conference.
Reserved -- -- --
CO Dial Delay Timer 00-99
(2 digits)
01
(100ms)
Voice connection to the outside party will be made after
this timer. This can be used to prevent illegal dialing in
case of slow response from the Central Office Line or
PBX.
CO Release Guard Timer 001-150
(3 digits)
020
(100ms)
The CO Release Guard Timer controls the time
necessary to guarantee idle loop state when the line is
released.
CO Ring Off Timer 001-150
(3 digits)
060
(100ms)
This timer is to secure time interval between incoming
ringing signals so that the active ringing can be continued
in the system until this timer expires.
CO Ring On Timer 1-9
(1 digit)
2
(100ms)
The CO Ring On Timer controls the time necessary to
detect an outside line as ringing into the system.
CO Warning Tone Timer 060-900
(3 digits)
180
(sec)
Establishes the amount of time before receiving warning
tone to remind of the call elapsed time in case of outgoing
CO conversations.
VM Outbound Retry
Counter
0-9
(1 digit)
2
System Timers - I (PGM 180)
ITEM RANGE DEFAULT REMARK
To Next Page
Loading...
