Chapter 4 Inputs / Outputs ALPHA V40
Version 18.07.06
27
Connection to AC Power (230 / 115 VAC)
Please read these notes before connecting the display controller to the AC power!
Note: This applicator is designed for interference free voltage of 115 /230 VAC,
(configurable). If the voltage is substantially lower or higher than 115 /230 VAC, the
applicator may function improperly.
The power inlet on the rear panel contains the main power switch to turn on/off the complete
Label Applicator (Fig. 4-1 on page 26 ). This sequence is to be used whenever the AC power is
turned on.
1. Turn OFF the main applicator power switch located on the controller rear panel.
2. Connect the end of an unplugged AC power cord to the IEC receptacle at the side of the
applicator.
3. Plug the other end of the AC power cord into an electrical outlet (115/230VAC).
4. Turn the applicator power switch ON ( I ).
To Next Page
Loading...
Need help?
General