Chapter 6 Display-Controller ALPHA V40
Version 18.07.06
70
GAP LEVEL
The gap between labels is detected when the photo sensor reads a value lower than this
parameter. It is automatically set by the sensor calibration procedure. In special cases a
manually set is possible (see its description for a practical rule to set this parameter, page 73).
Press either [] or [] key to move to the next setting.
Use the [Enter]-key to edit the parameter. The [] and []-keys increase or decrease the
value. It can range from 0 to 255. Press the [Enter]-key again to confirm your settings.
LABEL LEVEL
The label is detected when the photo sensor reads a value higher than this parameter. It is
automatically set by the calibration procedure (see its description for a practical rule to set this
parameter manually).
Press either [] or [] key to move to the next setting.
Use the [Enter]-key to edit the parameter. The [] and []-keys increase or decrease the
value. It can range from 0 to 255. Press the [Enter]-key again to confirm your settings.
PROGRAMMING 01
GAP LEVEL: XXX
PROGRAMMING 01
LABEL LEVEL: XXX
To Next Page
Loading...
Need help?
General