Glossary ALPHA V40
Version 18.07.06
8
Static Stack:
A stack of labels that have been applied one on top of the other. When the applicator is setup
correctly, a static stack will have less than + or – 1/32 of an inch variation in any direction.
Tamp:
A mechanical device that receives a label and moves the label to a position where it is applied
to a product.
Tamp Blow Mode:
Mode in which the tamp remains in the retracted position until an apply signal is received. Upon
receipt of an apply signal, the tamp extends, the air blast applies the label, and the tamp
retracts to receive the next label. Tamp Blow mode is most suitable for operations requiring the
tamp to reach into a recessed area on the product.
Tamp Retract Mode:
Mode that determines whether the tamp retracts at the start or the end of an air blast.
Trailing Edge:
The trailing edge of the product triggers label application.
VAC:
Volts AC (Alternating Current). Also designated as ~.
Vacuum Generator:
A device that uses compressed air to create vacuum.
VDC:
Volts DC (Direct Current).
Web:
The label liner with labels still attached that feeds into the machine.
To Next Page
Loading...
Need help?
General