wsm M7060 - Page 115

GENERAL
M6060, M7060, WSM
G-92
Through the tire pressure is factory-set to the prescribed level,
it naturally drops slowly in the course of time. Thus, check it every
day and inflate as necessary.
 Recommended Inflation Pressure
• Keep the pressure shown below for normal use.
NOTE
• Keep the maximum pressure in front tires, if using a front
loader or when equipped with lots of front weight.
9Y1210828GEG0128US0
Tire sizes Inflation pressure
Front
9.5-20 210 kPa (2.1 kgf/cm
2
, 30.5 psi)
12.5 / 80-18
(14.9-28)
420 kPa (4.2 kgf/cm
2
, 60.9 psi)
320 / 70R20 140 kPa (1.4 kgf/cm
2
, 20.3 psi)
320 / 85R20 140 kPa (1.4 kgf/cm
2
, 20.3 psi)
9.5-24 180 kPa (1.8 kgf/cm
2
, 26.1 psi)
300 / 70R20 240 kPa (2.4 kgf/cm
2
, 34.8 psi)
15.0 / 70-18 360 kPa (3.6 kgf/cm
2
, 52.2 psi)
8.3R24 310 kPa (3.1 kgf/cm
2
, 45.0 psi)
9.5R24 160 kPa (1.6 kgf/cm
2
, 23.2 psi)
340 / 80R18 180 kPa (1.8 kgf/cm
2
, 26.1 psi)
Rear
380 / 85R28
(14.9-28)
140 kPa (1.4 kgf/cm
2
, 20.3 psi)
18.4-26 170 kPa (1.7 kgf/cm
2
, 24.7 psi)
420 / 70R28 120 kPa (1.2 kgf/cm
2
, 17.4 psi)
420 / 85R30
(16.9-30)
120 kPa (1.2 kgf/cm
2
, 17.4 psi)
380 / 85R28
(14.9R28)
160 kPa (1.6 kgf/cm
2
, 23.2 psi)
230 / 95R36 360 kPa (3.6 kgf/cm
2
, 52.2 psi)
270 / 95R38 240 kPa (2.4 kgf/cm
2
, 34.8 psi)
12.4R36 160 kPa (1.6 kgf/cm
2
, 23.2 psi)
9.5R40 240 kPa (2.4 kgf/cm
2
, 34.8 psi)
380 / 85R30 160 kPa (1.6 kgf/cm
2
, 23.2 psi)
440 / 80R28 160 kPa (1.6 kgf/cm
2
, 23.2 psi)
(A) Insufficient
(B) Standard
(C) Excessive
(D) Ground
KiSC issued 08, 2013 A