wsm M7060 - Disassembling Rear Axle; Brake Section; Rear Axle Case

REAR AXLE
M6060, M7060, WSM
3-S10
[4] DISASSEMBLING REAR AXLE
(1) Brake Section
Brake Shaft, Brake Disk, Steel Plate and Brake Plate
1. Remove the circlip (1)
2. Remove the brake shaft (6)with the brake disks (5) and steel
plates (3) (4).
(When reassembling)
• Place the brake disks (5) so that the holes (9) aligned to next
holes.
• Thickness of the steel plates (4) and the steel plate (3) is
difference.
• Reassemble the thick steel plate (3) for out side of rear axle.
9Y1210828RAS0016US0
(2) Rear Axle Case
Planetary Gear Support
1. Remove the retainer plate mounting screw (2) and retainer (1).
2. Remove the external circlip (3).
3. Carefully remove the planetary gear support (4).
4. Remove the internal gear (6) and pins (5).
(When reassembling)
• Be sure to insert the retainer plate (1).
9Y1210828RAS0017US0
(1) Circlip
(2) Collar
(3) Steel Plate (Thick)
(4) Steel Plate
(5) Brake Disk
(6) Brake Shaft
(7) Brake Plate
(8) O-ring
(9) Hole
Tightening torque
Retainer plate mounting
screw
60.8 to 70.6 N·m
6.2 to 7.2 kgf·m
44.9 to 72.3 lbf·ft
(1) Retainer Plate
(2) Screw
(3) External Circlip
(4) Planetary Gear Support
(5) Pin
(6) Internal Gear
KiSC issued 08, 2013 A