GENERAL
M6060, M7060, WSM
G-96
(3) Rear Wheels
Rear tread width can be adjusted as shown with the standard
equipped tires.
To change the tread width
1. Remove the wheel rim and / or disc mounting bolts.
2. Change the position of the rim and disc (right and left) to the
desired position, and tighten the bolts.
• Always attach wheels as shown in the figure.
• If not attached as illustrated, transmission parts may be
damaged.
• When re-fitting or adjusting a wheel, tighten the bolts to the
following torques then recheck after driving the tractor 200
m (200 yards) and 10 times of shuttle movement by 5 m (5
yards), and thereafter according to service interval. (See
page G-24.)
Disc : Manufactured by TITAN INTERNATIONAL INC.
Disc : Other manufactured
(To be continued)
Tightening
torque
Rear wheel mounting nut
(4WD)
M16
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
Tightening
torque
Rear disc mounting nut
(steel disc) (4WD)
M16
244 N·m
24.9 kgf·m
180 lbf·ft
Rear disc mounting nut
(cast iron disc) (4WD)
M16
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
Tightening
torque
Rear disc mounting nut
(Both steel disc and cast
iron disc)
M16
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
(1) Rear Wheel Mounting Nut (2) Rear Disc Mounting Nut
To Next Page
Loading...
