wsm M7060 - PTO Clutch Pack

TRANSMISSION
M6060, M7060, WSM
2-S44
(2) PTO Clutch Pack
Removing PTO Clutch Pack and Holder
1. Pull out the pin (2) with sliding hammer (3). (See page G-74.)
2. Remove the hydraulic pump drive gear (1).
3. Remove the PTO clutch holder mounting screws.
4. Remove the PTO clutch (4) with holder (5).
(When reassembling)
9Y1210828TRS0068US0
Tightening torque
PTO clutch holder
mounting screw
23.5 to 27.4 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 lbf·ft
(1) Gear
(2) Pin
(3) Sliding Hammer
(4) PTO Clutch
(5) Holder
KiSC issued 08, 2013 A