wsm M7060 - Page 275

TRANSMISSION
M6060, M7060, WSM
2-S12
Adjusting Main Gear Shift
1. Make sure that there are sufficient grease applied to the sliding
position 1 "a" and sliding position 2 "b".
2. If the main gear shift lever has play or does not shift smoothly,
tighten the lock nut (2) to adjust.
3. When the main gear shift lever (5) is in neutral position, be sure
that the main gear shift lever (5) position is in the middle position
("A", "B") of the main gear shift lever guide.
If it is not, loosen the nuts (1) and adjust the position of the main
gear shift lever (5) or fine-adjust the length "L1" and "L2" of the
main shift rod 1 and 2.
4. When you shift the main gear shift lever (5) in all position, be
sure that the clearance "C" between the main gear shift lever
(5) and lever guide is same value shown in left figure.
If it is not, loosen the nuts (1) and adjust position of the main
gear shift lever (5) or fine-adjust the length "L2" of the main shift
rod 2.
ROPS Model
CABIN Model
9Y1210828TRS0007US0
(1) Main Gear Shift Lever
Mounting Nut
(2) Lock Nut
(3) Main Shift Rod 1
(4) Main Shift Rod 2
(5) Main Gear Shift Lever
A : Length of the main gear
shift lever guide 1
B : Length of the main gear
shift lever guide 2
C : Clearance
L1 : Length 1 of the main gear
shift rod
L2 : Length 2 of the main gear
shift rod
a : Sliding Position 1
b : Sliding Position 2
Length of main shift rod 1
"L1"
Factory specification
135 mm
5.31 in.
Length of main shift rod 2
"L2"
Factory specification
179 mm
7.05 in.
Length of main shift rod 1
"L1"
Factory specification
192 mm
7.56 in.
Length of main shift rod 2
"L2"
Factory specification
209 mm
8.23 in.
KiSC issued 08, 2013 A