BRAKES
M6060, M7060, WSM
4-S5
3) Equalizer Working Level (Anti-imbalance device)
1. Gently step on both the right and left pedals at once.
2. Further step on the right pedal (the left pedal slightly rises itself)
and measure the level difference between the pedals.
3. Do the same for left pedal.
4. If the measurement is not within the factory specification, check
the equalizer (2).
9Y1210828BRS0007US0
Brake Test
1. Remove the bleeder (1) from the brake case and set the
hydraulic brake adaptor, joint (Code No. 07916-50401), cable
(Code No. 07916-50331) and pressure gauge (Code No.
07916-52961).
2. Set the pedal fixing plate between the pedal and pedal stopper
after depressing the brake pedal to reach the pressure between
3.0 to 3.2 MPa (30 to 33 kgf/cm
2
, 430 to 460 psi).
3. Read the pressure P after one minute.
4. After reading the pressure P, wait another five minutes to read
the pressure P and check the pressure drop. The pressure drop
should be within P × 0.01 MPa (P × 0.1 kgf/cm
2
, P × 1 psi).
5. If the pressure drop is too big, attach the pressure gauge to
equalizer (brake pipe rear end) and master cylinder (brake pipe
front end) to find out the problem area.
• If the air is in the master cylinder, brake pipe and case bleed
the air completely.
9Y1210828BRS0008US0
Level difference between
both pedals
Factory specification
Over
5 mm
0.2 in.
(1) Master Cylinder (2) Equalizer
Tightening torque Bleeder
6.5 to 6.8 N·m
0.66 to 0.70 kgf·m
4.8 to 5.0 lbf·ft
(1) Bleeder
To Next Page
Loading...
