GENERAL
M6060, M7060, WSM
G-14
(Continued)
9Y1210828GEG0007US0
Engine Oil:
• Oil used in the engine should have an American Petroleum Institute (API) service classification and
Proper SAE Engine Oil according to the ambient temperatures as shown above.
• Refer to the following table for the suitable API classification engine oil according to the engine type (with
DPF (Diesel Particulate FIlter) type engines) and the fuel.
Fuel :
• Use the ultra low sulfur diesel fuel only [below 0.0015 % (15 ppm)] for these engines.
• Cetane number of 45 minimum. Cetane number greater than 50 is preferred, especially for temperatures
below −20 °C (−4 °F) or elevations above 1500 m (5000 ft).
• Diesel fuels specified to EN 590 or ASTM D975 are recommended.
• No.2-D is a distillate fuel of lower volatility for engines in industrial and heavy mobile service. (SAE J313
JUN87).
Transmission Oil:
*KUBOTA Super UDT-2 : For an enhanced ownership experience, we highly recommend Super UDT-2 to be
used instead of standard hydraulic/transmission fluid.
Super UDT-2 is a proprietary KUBOTA formulation that deliveries superior performance and protection in all
operating conditions.
Regular UDT is also permitted for use in this machine.
• Indicated capacities of water and oil are manufacturer's estimate.
9Y1210828GEG0008US0
Greasing
No. Place No. of greasing point Capacity Type of grease
8
Front axle gear case
support
2
Until grease overflows
Multipurpose
NLGI-2 or NLGI-1
(GC-LB) grease
Front axle support 2
Top link 2
Top link bracket 2
Lift rod 2
Hydraulic lift cylinder
pin
4
Steering joint shaft
[CABIN model]
1
Battery terminal 2 A small amount
Fuel used
Engine oil classification (API classification)
Oil class of engines with DPF
Ultra Low Sulfur Fuel [< 0.0015 % (15 ppm)] CJ-4
To Next Page
Loading...
Need help?
General
