CABIN
M6060, M7060, WSM
9-S6
3. TIGHTENING TORQUES
Tightening torques of screws, bolts and nuts on the table below are especially specified.
(For general use screws, bolts and nuts: Refer to "5. TIGHTENING TORQUES" on page G-15.)
9Y1210828CAS0003US0
Item N·m kgf·m lbf·ft
Rear wheel mounting nut 260 to 304 26.5 to 31.0 191.8 to 224.2
Compressor bracket mounting screw (M8) to aluminum
parts
18 to 20 1.8 to 2.1 13 to 15
Compressor bracket mounting screw (M8) to
ordinariness parts
24 to 27 2.4 to 2.8 18 to 20
Compressor bracket mounting screw (M10) to
ordinariness parts
48 to 55 4.9 to 5.7 36 to 41
High pressure hose mounting screw (compressor side) 7.9 to 11 0.80 to 1.2 5.8 to 8.6
Low pressure hose mounting screw (compressor side) 7.9 to 11 0.80 to 1.2 5.8 to 8.6
Master cylinder hose retaining nut 24 to 27 2.4 to 2.8 18 to 20
Power steering joint shaft mounting screw 24 to 27 2.4 to 2.8 18 to 20
Brake hose retaining nut 24 to 27 2.4 to 2.8 18 to 20
Cabin mounting screw and nut 124 to 147 12.6 to 15.0 91.2 to 108
Compressor mounting screw 25 to 29 2.5 to 3.0 18 to 21
Magnetic clutch mounting screw 15 to 21 1.5 to 2.1 11 to 15
A/C unit mounting screw (M8) 9.8 to 15 1.0 to 1.6 7.3 to 11
Pressure hose joint mounting screw (cooler unit side) 7.9 to 11 0.80 to 1.2 5.8 to 8.6
High pressure pipe mounting screw (condenser side) 7.9 to 11 0.80 to 1.2 5.8 to 8.6
High pressure pipe retaining nut (receiver side) 12 to 14 1.2 to 1.5 8.7 to 10
Wiper arm mounting nut (front wiper) 6.9 to 9.8 0.70 to 1.0 5.1 to 7.2
Wiper arm mounting nut (rear wiper) 7.9 to 9.8 0.80 to 1.0 5.8 to 7.2
Wiper motor mounting screw 7.9 to 9.8 0.80 to 1.0 5.8 to 7.2
To Next Page
Loading...
