Xerox 8830 Service Manual

REP 4.1.1 Document Loading Bins
Parts List on 1.1
Removal
WARNING
Switch off the Scanner and disconnect the Power Cord.
Replacement
For each Document Loading Bin:
1. (Figure 2): Replace the Document Loading Bins.
NOTE: Then are two Document Loading Bins on the front of the 7356 Scanner with 8830 DDS
configuration. For each Loading Bin perform the following:
1. (Figure 1): Remove the Document Loading Bins.
Pull out the wire ends of the Loading Bin from the
underside of Feed Tray and remove the Loading Bin
A
Loosen and
remove two
mounting
screws from
underside of
feed tray
B
Swing Document
Loading Bin
upward so that the
straight portion la
parallel to the
ground.
07O0003A-WHG
B
Insert the wire ends of the
Loading bin into holes on the
underside of the Feed Tray
Swing the Docu-
ment Loading Bin
downward to rest
against the Front
Panel
Ensure the Loading Bin
frame Is pressed flush up
against underside of Feed
Tray
Hold the straight edge of
the Document Loading
Bin parallel to the
ground
Insert and tighten
the mounting
screws to the under-
side of the Feed
Tray
0700003A-WHG
Figure 1 Removing the Document Loading Bins
Figure 2 Replacing the Document Loading Bins
8830 DDS
3/98
4-3
Repairs / Adjustments
REP 4.1.1
c
c
A

Xerox 8830 Specifications

General

Brand	Xerox
Model	8830
Category	Printer
Language	English