Repack Procedure
1. Power off the 7356 Scanner, the 8830 Controller, and the 8830 Printer. Disconnect the
printer and scanner power cables.
2. Remove the Document Loading Bins (2) from the front of the 7356 Scanner by performing
the removal procedure in REP 4.1.1 of this manual.
3. Disconnect the 7356 Scanner and SCSI Interface cables. Roll up the cables and secure
with tape. Place the cables on the Scanner Feed Shelf.
4. Disconnect the 8830 DDS Control Pane! cable from the two locations of the 8830 Control-
ler Connector Panel. Roll up the cable and secure with tape. Place the cable on the Scan-
ner Feed Shelf.
5. Remove the 7356 Scanner Document Catch Trays (2) from the Wire Form Assembly at
the back of the scanner. (They lift off the Wire Form Assembly.) Place the Catch Trays on
top of the cables already placed on the scanner Feed Shelf.
6. Remove the Wire Form Assembly from the back of the 7356 Scanner by performing the
removal procedure in REP 4.1.2 of this manual.
7. Place the Document Loading Bins (2) and the Wire Form Assembly directly in front of the
7356 Scanner for the rigging crew.
3/98 General Procedures
8830 DDS
6-25 Repack Procedure
To Next Page
Loading...
