Installation of Tags 7 and 8
NOTE: The purpose of this kit Is to upgrade the 8830 Controller to enable the Installation of the
8830 DDS product configuration.
Kit Contents
Table 1 Kit Contents
Item
1
2
3
4
6
6
7
8
9
Description
Instructions
Plate, Connector Panel
Harness, Power
Harness, Signal
Screw, Lock Assembly
Screw, Phillips Head, 3/16
Lock Washer, #2
EME Clamps
EME Gaskets
Quantity
1
1
1
1
2
4
4
4
2
Procedure
WARNING
Switch off the 8830 Printer power and disconnect the power cord from the back of the
printer.
1. Remove all cables connected to (he 8830 Controller Connector Panel.
2. (Figure 1): Remove the 8830 Controller.
Remove 2 screws
from Printer Right
Lower Cover
CAUTION
Certain components on this product are susceptible to damage from electrostatic discharge.
Observe all ESD procedures to avoid component damage.
Printer Right
Lower Cover
NOTE: Tag 7 updates the 8830 Controller to make It compatible for use within the 8830 Digital
Document System. Tag 8 consists of a group of ferrlte clips and gaskets that provide additional
EME protection tor the 8830 Controller.
Set 8830 Control-
ler on the floor
Disconnect connector A1J3
from A1P3
Disconnect ribbon
cable from printer
Figure 1 Removing the 8830 Controller
8830 DOS
3/98
6-27
General Procedures
Installation of Tags 7 and 8
To Next Page
Loading...
