Xerox 8830 - Page 455

8. (Figure 4): Flip the assembly over and remove the screws that fasten the 8830 printer
Right Lower Cover to the 8830 Controller chassis.
B
Remove 2 screws
securing Connector
Panel Plate to MCB
A
Remove 6
screws
Disconnect P12.P11.P3, P5. and P9
Connector
Panel side
Figure 5 Disconnecting the connectors from the MCB and PMC PWB
Figure 4 Rear view of 8830 Controller showing screws to be removed from the 8830
Printer Right Lower Cover
9. Remove the 8830 Printer Right Lower Cover from the 8830 Controller Chassis and set It
aside.
NOTE: For clarity, the following Illustration shows the MCB and the PMC PWB only.
10. (Figure 5): Set the 8830 Controller on a table top with the Inside of the module facing up.
Disconnect P12, P11, P3, PS, and P9 from the MCB and PMC PWB.
8830 DDS
3/98
6-29
General Procedures
Installation of Tags 7 and 8