Xerox WorkCentre 3550 - ADJ 5.1 DADF Side Edge Registration Adjustment

April 2010
4-47
Phaser 3635MFP/WorkCentre 3550
ADJ 5.1
Repairs and Adjustments
ADJ 5.1 DADF Side Edge Registration Adjustment
Purpose
To correctly set the DADF side edge registration.
Procedure
Perform the following:
1. Remove the input tray assembly, PL 5.15 Item 2.
2. Remove the lower cover, PL 5.15 Item 1.
3. Carefully move both document guide racks to the front or the rear to adjust the registra-
tion, PL 5.20 Item 4.
NOTE: Moving both document guides 1 tooth on the pinion gear (PL 5.20 Item 5) will
adjust the registration by approximately 3mm (0.1 inch).
4. Assemble the input tray assembly.
5. Use the DADF to make 10 copies of a document. Check the registration, refer to IQS 3
Registration. If necessary, re-adjust the registration.