April 2010
4-27
Phaser 3635MFP/WorkCentre 3550
REP 9.1
Repairs and Adjustments
REP 9.1 CRUM PWB
Parts List on PL 9.10
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to GP 10 General Disassembly Precautions.
1. Remove the DADF, PL 5.10 Item 1.
2. 3635 only. Remove the UI assembly, REP 2.1.
3550 only. Remove the UI assembly, REP 2.3.
3. Remove the rear cover assembly, REP 28.1.
4. Remove the scanner assembly, REP 14.1.
5. Remove the outbin, REP 28.2.
6. Remove the LSU, REP 6.1.
7. 3635 only. Disconnect CN17 from the Main PWB.
3550 only. Disconnect CN 25 from the Main PWB.
8. Remove 1 screw, then the CRUM PWB, PL 9.10 Item 7.
Replacement
1. Replacement is the reverse of the removal procedure.
To Next Page
Loading...
