Xerox WorkCentre 3550 - GP 17 Restriction of Hazardous Substances (Rohs); GP 18 Scan Edge (3635 Only)

April 2010
6-31
Phaser 3635MFP/WorkCentre 3550
GP 17, GP 18
General Procedures/Information
GP 17 Restriction of Hazardous Substances (RoHS)
Purpose
To give information on the RoHS Directive.
The RoHS Directive restricts the use of certain hazardous substances in electrical and elec-
tronic equipment. It applies to equipment placed in the European Union (EU) market. The
directive takes effect from 1st July 2006.
NOTE: Currently these restrictions are only for the European Union (EU) market and some
associated countries. For more information go to www.Xerox.com.
The hazardous substances are:
• Lead (Pb)
• Mercury (Hg)
• Cadmium (Cd)
• Hexavalent Chromium (Cr 6+, Cr [VI])
• Polybrominated Diphenyl Ethers (PBDE’s)
• Polybrominated Biphenyls (PBB’s)
Identification of a RoHS Compliant Machine
Xerox will maintain a central list of RoHS compliant machines.
This general procedure is for information only. All Phaser 3635MFP machines are RoHS com-
pliant.
GP 18 Scan Edge (3635 Only)
Use this procedure to test the document edge detection routine.
Procedure
NOTE: Before performing the scan edge print, ensure the DADF is lowered.
Perform the following:
1. Enter diagnostics, GP 1 Diagnostics Entry.
2. Select Diagnostic Routines.
3. Select Other Routines.
4. Select Scan Edge.
5. Select Print. The scan edge print will be printed.
6. If the following co-ordinates are displayed, the scan edge print is good:
Valid Image [ 0: 96] [ 0: 108]
Scan Image [ 0: 384] [ 0: 432]