Yamaha WaveRunner - Oil Filter Removal and Installation; Engine Unit Removal

5-6
E
POWR
ENGINE UNIT
7. Install:
• Ignition coils
• Air filter element
• Air filter case cover
Oil filter removal and installation
1. Remove:
• Oil filter
1
NOTE:
Install the oil filter with the same special tool
that was used for removal.
Engine unit removal
1. Remove:
• Engine unit
T
R
.
Ignition coils bolt:
7.6 N • m (0.76 kgf • m, 5.5 ft • lb)
LOCTITE 572
Air filter case cover screw:
2.5 N • m (0.25 kgf • m, 1.8 ft • lb)
LOCTITE 572
Oil filter wrench:
YU-38411/90890-01426
T
R
.
Oil filter:
17 N • m (1.7 kgf • m, 12 ft • lb)
Removal steps:
CAUTION:
Lift the engine unit carefully trying not to
hit it on the deck or letting it fall hard on
the hull.
• Suspend the engine unit using all three
engine hangers, and then separate the
unit from the engine mount.
• Remove the hoist cable from the front
engine hanger and use the two rear
engine hangers to suspend the engine
unit.
• Lift the engine unit out vertically while
turning it clockwise.
1