Yamaha WaveRunner - Diagnostic Display; Checking the Remote Control Transmitter

7-53
E
– +
ELEC
REMOTE CONTROL SYSTEM
Diagnostic display
1. Check:
• Diagnostic display
Does not display
→
Replace the multi-
function meter.
Checking steps:
• Start the engine.
• Disconnect the coupler of a sensor (e.g,.
engine temperature sensor) that is nor-
mally displayed when a malfunction
occurs. Refer to “SELF-DIAGNOSIS” in
Chapter 9.
• Check that the check engine warning
indicator is displayed and that the buzzer
sounds.
• Press the select switch
1
for 8 seconds
and check the error code indicated on the
multifunction meter.
1
Checking the remote control transmitter
1. Check:
• Remote control transmitter
Does not operate
→
Replace the remote
control transmitter.
Checking steps:
CAUTION:
If the buttons on the remote control
transmitter are pushed but the transmit-
ter does not operate, the battery may be
low.
• Press the lock button
1
of the remote
control transmitter. The beeper sounds
once.
• Check that the “SECURITY” indicator
light goes off and the engine cannot be
started.
• Press the unlock button
2 of the remote
control transmitter for a short time. The
beeper sounds two or three times.
• Check that the “SECURITY” indicator
light comes on and the engine can be
started.
1
2