Yamaha WaveRunner - Drain Plug Inspection; Lubrication Points

3-29
E
INSP
ADJ
GENERAL
GENERAL
Drain plug inspection
1. Inspect:
• Drain plugs
Cracks/damage
→
Replace.
• O-rings
Cracks/wear
→
Replace.
• Screw threads
Contaminants
→
Clean.
Lubrication points
1. Lubricate:
• Throttle cable (handlebar end)
NOTE:
Before lubricating the throttle cable, squeeze
the throttle lever and remove the rubber seal
1
.
2. Lubricate:
• Throttle cable (throttle body end)
Recommended lubricant:
Rust inhibitor
Recommended lubricant:
Yamaha marine grease,
Yamaha grease A
(Water resistant grease)
3. Lubricate:
• QSTS control cables (handlebar end)
NOTE:
Before lubricating the QSTS control cables,
remove the QSTS cable housing cover. Spray
the rust inhibitor into the outer cables, and
apply grease to the inner cables.
Recommended lubricant:
Yamaha marine grease,
Yamaha grease A
(Water resistant grease)