116
E
HULL
HOOD
REBOARDING STEP (For FX Cruiser/FX
Cruiser High Output)
SERVICE POINTS
Reboarding step installation
1. Install:
• Reboarding step
Installing steps:
• Fasten the brackets on both sides of the
reboarding step in the down position with
a plastic tie
1
as shown in the illustra-
tions so that they will not return to the up
position.
• Finger tighten all of the bolts, and then
tighten them to specification.
T
R
.
Bolt:
15 N • m (1.5 kgf • m, 11 ft • lb)
1
1
To Next Page
Loading...
