Yamaha WaveRunner - Periodic Inspection and Adjustment

E
INSP
ADJ
3
CHAPTER 3
PERIODIC INSPECTION AND ADJUSTMENT
MAINTENANCE INTERVAL CHART .............................................................. 3-1
PERIODIC SERVICE.......................................................................................3-2
CONTROL SYSTEM .................................................................................3-2
Steering master inspection..................................................................3-2
Steering cable inspection and adjustment ..........................................3-2
Throttle cable inspection and adjustment............................................3-3
QSTS cable inspection and adjustment..............................................3-5
Shift cable inspection and adjustment.................................................3-7
Trolling speed check and adjustment..................................................3-8
FUEL SYSTEM..........................................................................................3-9
Fuel line inspection .............................................................................3-9
Water separator inspection ...............................................................3-10
POWER UNIT..........................................................................................3-10
Valve clearance adjustment..............................................................3-10
Engine oil level check........................................................................3-16
Engine oil change — using oil changer.............................................3-18
Air filter element clean.......................................................................3-20
Spark plug inspection........................................................................3-21
ELECTRICAL ..........................................................................................3-24
Battery inspection..............................................................................3-24
JET PUMP UNIT .....................................................................................3-27
Impeller inspection ............................................................................3-27
Water inlet strainer inspection...........................................................3-27
BILGE PUMP...........................................................................................3-28
Bilge strainer inspection....................................................................3-28
Electric bilge pump strainer inspection..............................................3-28
GENERAL ...............................................................................................3-29
Drain plug inspection.........................................................................3-29
Lubrication points..............................................................................3-29