41
E
INSP
ADJ
MAINTENANCE INTERVAL CHART
MAINTENANCE INTERVAL CHART
The following chart should be considered strictly as a guide to general maintenance intervals.
Depending on operating conditions, the intervals of maintenance should be changed.
*1: Grease quantity: 33.0–35.0 cm
3
(1.11–1.18 oz)
*2: Grease quantity: 6.0–8.0 cm
3
(0.20–0.27 oz)
*3: After every use
MAINTENANCE INTERVAL INITIAL THEREAFTER EVERY
10 hours 50 hours 100 hours 100 hours 200 hours
ITEM 6 months 12 months 12 months 24 months
Spark plug Inspect, clean, adjust
Lubrication points Lubricate
Intermediate housing Lubricate *1 *2 *2
Fuel system Inspect
Fuel tank Inspect, clean
Trolling speed Inspect, adjust
Throttle shaft Inspect
Cooling water passages Flush *3
Water inlet strainer Inspect, clean
Bilge strainer Clean
Electric bilge pump strainer Inspect, clean
Impeller Inspect
Jet thrust nozzle angle Inspect, adjust
Steering master Inspect
QSTS mechanism Inspect, adjust
Shift cable and mechanism Inspect, adjust
Throttle cable Inspect, adjust
Stern drain plugs Inspect, replace
Battery Inspect
Rubber coupling Inspect
Engine mount Inspect
Nuts and bolts Inspect
Air filter Inspect, replace
Engine oil Replace
Engine oil filter Replace
Valve clearance Inspect, adjust