Yamaha WaveRunner - QSTS Cable Inspection and Adjustment

3-5
E
INSP
ADJ
CONTROL SYSTEM
WARNING
After adjusting the free play, turn the han-
dlebar to the right and left and make sure
that the trolling speed does not increase.
h. Install the handlebar cover.
T
R
.
Handlebar cover screw:
1.1 N • m (0.11 kgf • m, 0.8 ft • lb)
LOCTITE 242
i. Install the ribbon sub assemblies and air
filter case cover.
T
R
.
Ribbon sub assembly bolt:
6.5 N • m (0.65 kgf • m, 4.7 ft • lb)
LOCTITE 242
Air filter case cover screw:
2.5 N • m (0.25 kgf • m, 1.8 ft • lb)
LOCTITE 572
QSTS cable inspection and adjustment
1. Measure:
• Jet thrust nozzle set length
a
,
b
Difference
→
Adjust.
Measurement steps:
• Set the control grip in the neutral position.
• Set the jet thrust nozzle in the center
position.
• Measure the jet thrust nozzle set length
a
and
b
.
• If
a
and
b
lengths are not even, adjust
the cable joint.