Yamaha WaveRunner - Maintenance Interval Chart

3-1
E
INSP
ADJ
MAINTENANCE INTERVAL CHART
MAINTENANCE INTERVAL CHART
The following chart should be considered strictly as a guide to general maintenance intervals.
Depending on operating conditions, the intervals of maintenance should be changed.
*1: Grease quantity: 33.0–35.0 cm
3
(1.11–1.18 oz)
*2: Grease quantity: 6.0–8.0 cm
3
(0.20–0.27 oz)
*3: After every use
MAINTENANCE INTERVAL INITIAL
THEREAFTER
EVERY
PAGE
10 hours 50 hours 100 hours 100 hours 200 hours
ITEM
6
months
12
months
12
months
24
months
Spark plug Inspect, clean, adjust 3-21
Lubrication points Lubricate 3-29
Intermediate housing Lubricate *1 *2 *2 3-31
Fuel system Inspect 3-9
Fuel tank Inspect, clean 3-9
Trolling speed Inspect, adjust 3-8
Throttle shaft Inspect —
Cooling water passages Flush *3 —
Water inlet strainer Inspect, clean 3-27
Bilge strainer Clean 3-28
Electric bilge pump
strainer
Inspect, clean 3-28
Impeller Inspect 3-27
Jet thrust nozzle angle Inspect, adjust 3-2
Steering master Inspect 3-2
QSTS mechanism Inspect, adjust 3-5
Shift cable and
mechanism
Inspect, adjust 3-7
Throttle cable Inspect, adjust 3-3
Stern drain plugs Inspect, replace 3-29
Battery Inspect 3-24
Rubber coupling Inspect —
Engine mount Inspect 5-7
Nuts and bolts Inspect —
Air filter Inspect 3-20
Engine oil Replace 3-16
Engine oil filter Replace 3-18
Valve clearance Inspect, adjust 3-10