7-55
E
– +
ELEC
REMOTE CONTROL SYSTEM
Transmitter registration
1. Register:
• Remote control transmitter
1
ID codes can be added or re-registered
by connecting the entry box
2
.
Registration steps:
• Connect the entry box.
• Transmit the ID code from the remote
control transmitter to be registered.
NOTE:
The remote control transmitters can be reg-
istered in any sequence, regardless of
whether they are original equipment or
additional transmitters.
• At this time, the system enters the regis-
tration mode to register the first code. All
existing ID codes will be deleted from the
EEPROM.
• The “SECURITY” indicator light flashes
when the registration of the ID code has
been completed. (If the registration could
not be completed, the “SECURITY” indi-
cator light comes on. Re-transmit the ID
code.)
• After confirming that the registration of
the ID code has been completed using
the “SECURITY” indicator light, transmit
the next ID code.
• Register the ID codes for up to five
remote control transmitters.
• After ID code registration has been com-
pleted, disconnect the entry box to exit
the registration mode.
Gy
B
1
2
To Next Page
Loading...
