81
E
HULL
HOOD
HANDLEBAR
4. Install:
• Throttle cable seal
Installing steps:
• Install the throttle cable end into the throt-
tle lever.
• Fit the seal
1
into the groove in the
bracket as shown.
• Pull the throttle cable
2
in the direction of
the arrow shown in the illustration, and
then fit the end of the seal
3
around
inner cable.
• Turn the adjuster
4
in/out until the speci-
fied free play is obtained.
Throttle lever free play
a
:
4–7mm (0.16–0.28 in)
Turn in Free play is increased.
Turn out Free play is decreased.
• Tighten the lock nut
5
.
1
3
2
To Next Page