3-19
E
INSP
ADJ
POWER UNIT
2. Remove:
• Oil filler cap
1
1
3. Insert the tube of an oil changer into the oil
filler hole.
4. Operate the oil changer to extract the oil.
5. If the oil filter is also to be replaced, per-
form the following procedure.
6. Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
Replacing steps:
• Place a rag under the oil filter.
• Remove the oil filter
1
with an oil filter
wrench.
Oil filter wrench:
YU-38411/90890-01426
• Lubricate the O-ring
2 of the new oil filter
with a thin coat of engine oil.
CAUTION:
Make sure the O-ring
2
is positioned
correctly in the groove of the oil filter.
• Tighten the new oil filter to specification
with an oil filter wrench.
T
R
.
Oil filter:
17 N • m (1.7 kgf • m, 12 ft • lb)
1
To Next Page
Loading...
