4.4 Changing the Command
4.4.2 Operation after Changing the Motion Command
4-162
FEED
VELO
The motion command immediately switches to the VELO command, and
the control mode switches from position control to speed control. The travel
distance that is stored in the acceleration/deceleration filter is canceled.
Precautions
After switching to VELO, the VELO command operates without the acceler-
ation/deceleration filter. To enable the acceleration/deceleration filter, hold
the FEED operation by executing the NOP command. Then, check that bit 0
(Distribution Completed) in IW0C is 1 (Completed) before you execute
the VELO command.
TRQ
The motion command immediately switches to the TRQ command. The
control mode changes from position control to torque control.
At this time, the travel distance that is stored in the acceleration/decelera-
tion filter is canceled.
Precautions
After switching the command, the TRQ command operates without the
acceleration/deceleration filter because the acceleration/deceleration filter
is disabled for the TRQ command.
PHASE
The motion command immediately switches to the PHASE command, and
the control mode switches from position control to phase control.
Continued on next page.
Continued from previous page.
Command
before
Switching
Command
after
Switching
Operation
FEED
FEED VELO
FEED VELO
VELO
The speeds will change smoothly.
(Acceleration or deceleration is performed
to the target speed of the VELO
command based on the current speed
when the command was switched.)
The acceleration/deceleration lter is
disabled.
Motion command
Motion command
response
Position Control Mode
Speed Control Mode
FEED
FEED TRQ
FEED TRQ
TRQ
The reference value of the TRQ command
is output, regardless of the current speed
when the command is switched.
Motion command
Motion command
response
Position Control Mode
Torque Control Mode
FEED
FEED PHASE
FEED PHASE
PHASE
The reference value of the PHASE
command is output regardless of the current
speed when the command is switched.
Motion command
Motion command
response
Position Control Mode
Phase Control Mode
To Next Page
Loading...
