7.1 Module Configuration Settings
7.1.1 Settings for Motion Control Function Modules
7
Making Settings for Motion Control with the MPE720
7-3
Module Configuration Definition Tab Page Details
The following table describes the items that are displayed in the Module Configuration Defini-
tion Tab Page.
No. Item Display/Setting Item Setting Range/Settings Changing
Module
Displays the Module that is set for
the slot.
Any Module Possible
Function Module/Slave
Displays the Function Modules and
slaves that are used by the Mod-
ule.
Any Function Module or
slave
Possible
Status
In Online Mode, displays the status
of the Function Modules and the
communications status of MECHA-
TROLINK slave devices.
Refer to the following
section.
Status Display
Contents on page
7-4
Not possible
Circuit No./
Axis
Address
Start
Displays the first circuit number
that is assigned to the Function
Module.
Circuit No. 1 to 16 Possible
Occu-
pied cir-
cuits
Displays the number of circuits that
are assigned to the Function Mod-
ule.
1 or 2 Possible
Motion Register
Displays the first and last register
addresses of the motion parame-
ters.
The parameter is auto-
matically set based on the
circuit numbers.
Not possible
Register
(Input/Out-
put)
Disabled
Used to disable inputs or outputs
by selecting the check boxes.
Selected or not selected Possible
Start -
End
Displays the range of registers that
is used as an I/O area by the Func-
tion Module. For the SVC or
SVC32, the first and last registers
of the I/O Modules that are con-
nected to MECHATROLINK are
displayed.
Start: 0000 to 7FFF hex
End: 10000 to 17FFFF
hex, 800 hex words max.
*
Possible
Size
Displays the number of words in
the I/O area.
1 to 1024 Possible
Scan
Displays the scan in which the I/O
service is performed for the I/O
device.
High/Low Possible
Continued on next page.
To Next Page
Loading...
