7.1 Module Configuration Settings
7.1.1 Settings for Motion Control Function Modules
7-4
* Set I/O registers so that the same registers are not used by more than one Function Module.
Status Display Contents
The items displayed in the Status Column are listed below.
Status of the CPU, Communications Function Modules, Motion Control Function
Modules, and Option Modules
The following will be displayed as the status of the CPU, Communications Function Modules,
Motion Control Function Modules, and Option Modules.
Transmission Status for the SVC Function Module
The following status is displayed for the SVC Function Module.
Comment Displays the user comment.
You can enter up to 16
characters for a Function
Module. You can enter up
to 32 characters for a
MECHATROLINK slave.
Possible
1. Always save all settings to the flash memory after changing them.
2. When changing the settings, be careful not to set register addresses that overlap with other
Function Modules.
3. Set I/O start and end registers even if an I/O Module is not connected to the MECHATROLINK
network.
Display Description
----- Undefined.
Empty Defined but not connected.
Driving Operating normally.
Failure Error detected.
×
The connected Module has a different name from the Module defined on the
Module Configuration Definition Tab Page.
Initializing The Module is connected but the Module configuration is not defined.
Driving Stop The CPU is stopped (The user programs are stopped).
Duplicate Address
The same station address is used for more than one connected MECHA-
TROLINK-III slave device.
Display Description
No Alarm Transmission is normal.
High Speed Scan Trans-
mission Error
A transmission error has occurred. (The high-speed scan is set for the I/O scan
for the station.)
Low Speed Scan Trans-
mission Error
A transmission error has occurred. (The low-speed scan is set for the I/O scan for
the station.)
Duplicate Address The same station address is set for more than one slave device.
Continued from previous page.
No. Item Display/Setting Item Setting Range/Settings Changing
Important
To Next Page
Loading...
