YASKAWA SVC - Page 485

9.3 Parameter Support Table
9.3.2 Setting Parameter Table
9
Stepping Motor Drive Operation
9-9
OW  05
Function Set-
tings 3
Bit 0: Reserved. – –
page 3-41
Bit 1: Disable Phase Reference Calcula-
tion
0: Enabled, 1: Disabled

Bit 2: External Positioning Final Travel
Distance Write Selection
0: Automatically apply
1: Do not automatically apply

Bits 3 to A: Reserved. – –
Bit B: Zero Point Return Input Signal
0: OFF, 1: ON

Bits C to F: Reserved. – –
OW
 06
M-III Vendor-
specific Servo
Command Out-
put Signal
Used as the Servo I/O areas. page 3-42
OW
 07 − Reserved. – – –
Continued on next page.
Continued from previous page.
Register
Address
Name Description
Step-
ping
Motor
Servo-
motor
Reference
Page