YASKAWA SVC - Page 491

9.3 Parameter Support Table
9.3.2 Setting Parameter Table
9
Stepping Motor Drive Operation
9-15
OL  68
Negative Soft-
ware Limit
1 = 1 reference unit page 3-67
OL
 6A − Reserved. – – –
OL  6C − Reserved. – – –
OL  6E − Reserved. – – –
OL
 70
User-specified
SERVOPACK
Parameter Set
Value
Enter the value to set for the SERVO-
PACK parameter that is set with fixed
parameter No. 44.
page 3-67
OW  68
to
OW  7F
Command Buf-
fers for SERVO-
PACK
Transmission
Reference Mode
This area is used for command data
when MECHATROLINK Servo com-
mands are specified directly.
–  page 3-67
Continued from previous page.
Register
Address
Name Description
Step-
ping
Motor
Servo-
motor
Reference
Page