YASKAWA SVC - Page 65

3.3 Motion Parameter Tables
3.3.2 Setting Parameter Table
3-12
OW05
Function Set-
tings 3
Bit 0: Reserved. – –
page 3-41
Bit 1: Disable Phase Reference Calcu-
lation
0: Enabled, 1: Disabled
 –
Bit 2: External Positioning Final Travel
Distance Write Selection
0: Automatically apply
1: Do not automatically apply
 –
Bits 3 to A: Reserved. – –
Bit B: Zero Point Return Input Signal
0: OFF, 1: ON
 –
Bits C to F: Reserved. – –
OW
06
M-III Vendor-
specific Servo
Command Out-
put Signal
This parameter is used as a vendor-
specific output area.
 – page 3-42
OW
07 − Reserved. – – −
Continued on next page.
Continued from previous page.
Register
Address
Name Description
SVC
Function
Module
SVR
Function
Module
Reference
Page