YOKOGAWA PX8000 User Manual

14-3
IM PX8000-02EN
Setting the Parameter Details (Detail Parameter)
2.
Press the Detail Parameter soft key to display the following screen.
Set the unit for the reference level (%, Unit).
Set the distal value.
Set the mesial value.
Set the proximal value.
When set to %: 0.0%-100.0%
When set to Unit: Within ±5 div of the source
waveform
Reference level
Set the mode for determining high and low
levels (Auto, Max-Min).
Set the integration mode (Normal, Hour).
Set this when the source waveform (Trace) is set
to I1-I4 or P1-P4.
Setting the Delay (Delay Setup)
2.
Press the Delay Setup soft key to display the following screen.
Set the reference waveform conditions.
(Set this when Reference is set to Trace.)
Set the delay value unit (OFF, Time, Degree).
Set the slope of the edge to be detected.
Set which counted edge to use as a detected
point (measured point) (1-9).
Set the delay measurement reference
(Trace, Trigger).
• Set the reference waveform
(U1-U4, I1-I4, P1-P4, AUX3-AUX8,
Math1-Math8).
• Set the slope of the edge to be detected.
• Set which counted edge to use as a
detected point (reference point) (1-9).
Copying Measurement Items to the Specified Channels (Copy to)
2.
Press the Copy to soft key to display the following screen.
Copies the contents specified by measurement item (Item)
to the selected waveforms (Trace)
(U1-U4, I1-I4, P1-P4, AUX3-AUX8, Math1-Math8)
Selects all waveforms
Starts copying
Unselects all waveforms
14.1 Automatically Measuring Waveform Parameters

YOKOGAWA PX8000 Specifications

General

Brand	YOKOGAWA
Model	PX8000
Category	Measuring Instruments
Language	English