3-22
IM 701240-01E
Phase Compensation Signal
The probe compensation signal output terminal (COMP terminal) delivers the following
rectangular wave signal.
Frequency: 1 kHz ± 1%
Amplitude: 1 V ± 10%
Differences in the Waveform Caused by the Phase Correction of the Probe
Correct waveform
Over compensated
(the gain in the high
frequency region is up)
Under compensated
(the gain in the high
frequency region is low)
Precautions to Be Taken When Using the Probe on the Frequency Module
(701280 (FREQ))
You cannot perform phase correction of the probe on the frequency module. When
connecting a probe to the frequency module, perform phase correction of the probe on
another module beforehand.
3.8 Compensating the Probe (Phase Correction)
To Next Page
Loading...
