9-20
IM 701240-01E
9.7 Reprinting on the Built-in Printer
<For a description of this function, refer to page 2-40.>
Procedure
Reprinting the Waveform Recorded in Chart Recorder Mode (T-Y Recording)
Before carrying out the procedure below, record the T-Y waveform in Chart Recorder
mode according to the procedures in sections 9.1 to 9.4. This section explains the
procedure from the point when the RECORD COND menu is displayed.
1. Press the Reprint Setup soft key.
Setting the Print Destination
2. Press the Print to soft key. The print destination selection menu appears.
3. Press the Printer soft key.
Selecting the Print Length
4. Press the Length soft key. The print length selection menu appears.
5. Press the Continue or A4 Print soft key.
Selecting the Section to Be Reprinted
6. Press the Window Mag/Window Pos soft key to select Window Mag.
7. Use the jog shuttle to set the zoom rate. You can reduce the zoom rate to
redisplay the waveform that had been cleared from the screen.
8. Press the Window Mag/Window Pos soft key to select Window Pos.
9. Use the jog shuttle to set the zoom position. You can move the zoom position
to redisplay the waveform that had been cleared from the screen.
10. If you select Continue in step 5, press the Start Point/End Point soft key.
11. Use the jog shuttle to set the start and end points of the section to be reprinted.
Setting the Print Magnification (Only If Continue Is Selected in Step 5)
12. Press the Print Mag soft key.
13. Use the jog shuttle to set the magnification of the section to be reprinted that
you selected in steps 6 to 11. The top row of the menu shows the magnification;
the bottom row shows the number of pages when the waveform is recorded
using the magnification indicated in the top row.
Start Point/End Point, Print Mag, and Preview are displayed only when Length is set to Continue.
To Next Page
Loading...
