YOKOGAWA SL1400 - Activating Triggers on the Power Signal (SIMPLE)

6-12
IM 701240-01E
6.7 Activating Triggers on the Power Signal
(SIMPLE)
<For a description of this function, refer to page 2-17.>
Procedure
1. Press MENU.
2. Press the TRIGGER soft key.
3. Press the Trigger Cond. Setup soft key.
4. Press the Select soft key to select Simple.
Setting the Trigger Source
5. Press the Source soft key. The trigger source selection menu appears.
6. Use jog shuttle+SELECT to select Line.
Setting the Hold Off
7. Set the hold off time according to the procedures given in section 6.4.
Explanation
A triggers can be activated on the rising edge of the power signal that is being supplied
to the SL1400. Waveforms synchronized to the commercial power supply frequency (50
Hz or 60 Hz) can be observed.
Trigger Source
Select Line. The power signal that is being supplied to the SL1400 becomes the trigger
source.
Hold Off
See section 6.4.