YOKOGAWA SL1400 - Recording T-Y Waveforms

9-11
IM 701240-01E
Recording in Recorder Mode
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
App
Index
9.4 Recording T-Y Waveforms
Procedure
Before carrying out the procedure below, set the recording conditions and recording
format of T-Y waveform recording according to the procedures in sections 9.2 and 9.3.
Starting the T-Y Waveform Recording
Press START/STOP. Waveform acquisition starts, and T-Y waveform recording
starts.
Stopping the T-Y Waveform Recording
Press START/STOP when T-Y waveform recording is in progress. Waveform
acquisition and T-Y waveform recording stop.
Explanation
Starting/Stopping the T-Y Waveform Recording
If you press START/STOP and start the waveform acquisition, T-Y waveform recording
to the built-in printer also starts. To abort the T-Y waveform recording, press START/
STOP to stop the waveform acquisition. However, if the T-Y waveform recording to the
built-in printer was set to OFF in section 9.2, the waveform is acquired only to the
internal memory. T-Y waveform recording to the built-in printer is not performed.
Changing the Settings during T-Y Waveform Recording
• You can change the input conditions even while T-Y waveform recording is in
progress. The recording does not stop.
• Calibration is not executed while the T-Y waveform recording is in progress.
• You cannot change the recording format while the T-Y waveform recording is in
progress.
• You can change the chart speed while the T-Y waveform recording is in progress.
However, the waveform acquired in the internal memory up to that point is cleared.
The waveform after the chart speed change is acquired in the internal memory.