17-12
IM 701240-01E
17.3 Self Test
Procedure
Displaying the Self Test Menu
1. Press MENU.
2. Press the Next 1/2 soft key.
3. Press the Self Test soft key.
4. Press the Test Item soft key. The test item selection menu appears. Use jog
shuttle+SELECT to select the item to be tested.
• Memory test: Proceed to step 5
• Key test: Proceed to step 7
• Printer test: Proceed to step 12
• PC card interface, internal hard disk, and SCSI tests: Proceed to step 14.
Executing the Memory Test
5. In step 4, select Memory.
6. Press the Test Exec soft key to execute the memory test.
Executing the Key Test
7. In step 4, select Key Board.
8. Press the Test Exec soft key to execute the key test.
9. Press all the keys or press ESC twice to end the key test.
• Testing the Soft Keys
10. Press the Soft Key soft key. A software keyboard appears.
11. Use jog shuttle+SELECT to check that all the characters on the keyboard can
be entered correctly.
Memory test Key test
Note
“FREQ VerUp” and “PRINTRE VerUp” that are displayed with the Test Item soft key are used
when updating the frequency module firmware and the built-in printer firmware. For details on
updating the firmware, go to the following website, and then browse to the download page.
http://www.yokogawa.com/ymi/
To Next Page
Loading...
