6-20
IM 701240-01E
6.11 Setting the A Delay B Trigger (ENHANCED)
<For a description of this function, refer to page 2-18.>
Procedure
1. Press MENU.
2. Press the TRIGGER soft key.
3. Press the Trigger Cond. Setup soft key.
4. Press the Select soft key to select Enhanced.
Setting the Trigger Type
5. Press the Type soft key. The trigger type selection menu appears.
6. Use jog shuttle+SELECT to select A Delay B.
Setting Condition A
7. Press the Set Pattern soft key. The A Delay B trigger setup menu appears.
Setting the Condition A Pattern
8. Use jog shuttle+SELECT to select the pattern of each channel (CH1 to CH16)
from H, L, and X. For logic input channels, select Disable or Enable.
Setting the Condition A Condition
9. Use jog shuttle+SELECT to set Condition to Enter or Exit.
Setting Condition B
10. Set the pattern and condition of condition B in a similar fashion as in steps 8 and
9.
Setting the Delay Time
11. Use jog shuttle+SELECT to set Delay. Pressing RESET resets the value to 0.0
µs.
To Next Page
Loading...
