9-16
IM 701240-01E
9.6 Recording X-Y Waveforms
<For a description of this function, refer to page 2-40.>
Procedure
Before carrying out the procedure below, select X-Y Recorder mode according to the
procedures in section 9.1.
1. Press MENU.
2. Press the RECORD COND soft key.
Setting the Sample Rate
3. Press the Sample Rate soft key.
4. Turn the jog shuttle to select the sample rate.
Setting the Interpolation Method
5. Press the Interpolation soft key. The interpolation selection menu appears.
6. Press the soft key corresponding to the desired interpolation method.
Setting the Auto Print Function
7. Press the Auto Print soft key to select ON or OFF. If you select ON, the X-Y
waveform recording on the built-in printer starts automatically when the
waveform acquisition stops.
Sample
rate
Record
time
Selecting the X-Y Waveform to Be Displayed (Recorded)
8. Press the Print Setup soft key. The print setup dialog box opens.
9. Use jog shuttle+SELECT to select XY1 to XY4, turn the display ON/OFF of
each X-Y waveform, and set the X trace and Y trace channels.
Setting the Graticule
Setting the Grid
10. Use jog shuttle+SELECT to select the type.
Setting Dark/Light
11. Use jog shuttle+SELECT to select dark or light.
Setting the Grid Width of the X- and Y-Axes
12. Use jog shuttle+SELECT to select the width.
To Next Page
Loading...
