13-14
IM 701240-01E
13.8 Saving and Loading Waveform Data
CAUTION
Do not remove the storage medium (disk) or turn OFF the power when the
access indicator or the PC card or internal hard disk (option) icon is blinking.
Doing so can damage the storage medium or destroy the data on the medium.
Procedure
Saving the Waveform Data
1. Press FILE.
2. Press the File Item soft key. The File Item setup menu appears.
3. Press the Waveform soft key.
Selecting the Data Type
4. Press the Data Type soft key. The data type selection menu appears.
5. Press the Binary, ASCII, or Float soft key to select the data type.
Note
• Binary files can be saved and loaded. ASCII and Float files can only be saved.
• Select Real Time when loading or converting the waveform that has been realtime
recorded. For details, see section 13.15.
• The data type is linked to the data type specified when Save to File is selected for the
action-on-trigger action (see section 6.18).
Selecting the Waveform to Be Saved
6. Press the Save soft key. The save setup menu appears.
7. Press the Trace soft key. The waveform selection menu appears.
8. Press the soft key corresponding to the desired channel to select the waveform.
To Next Page
Loading...
