3-3
IM 701240-01E
3
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
App
Index
Preparations for Measurements
3.2 Installing the Instrument
WARNING
• This instrument is designed to be used indoors. Do not install or use it outdoors.
• Install the instrument so that you can immediately remove the power cord if an
abnormal or dangerous condition occurs.
CAUTION
If you block the inlet or outlet holes on the SL1400, the SL1400 will become hot
and may break down.
Installation Conditions
Install the instrument in a place that meets the following conditions:
Flat, Even Surface
Set the instrument in the proper direction (see page 3-4) and in a level and stable place. Note
that the instrument can be tilted on the stand if the instrument is set with the rear panel facing
down. If placed in an uneven or unstable place, printing quality may deteriorate.
Well-Ventilated Location
There are inlet holes on the bottom side of the instrument. In addition, there are vent
holes for the cooling fans in the left side and top panels. To prevent internal overheating,
allow for enough space around the instrument (see the figure below) and do not block
the vent and inlet holes.
5 cm
or more
10 cm
or more
10 cm
or more
10 cm or more
When connecting various cables or when opening or closing the built-in printer cover,
provide extra space for operation in addition to the space indicated above.
To Next Page
Loading...
