6-45
IM 701240-01E
6
7
8
9
10
11
12
13
14
15
16
17
18
App
Index
Triggering
6.18 Setting the Action-on-Trigger
<For a description of this function, refer to page 2-26.>
Procedure
1. Press MENU.
2. Press the TRIGGER soft key.
3. Press the ACTION soft key.
Setting the Action
4. Press the Mode soft key. The Mode setup menu appears.
5. Press the On Trigger soft key.
6. Press the Action soft key. The Action setup menu appears.
7. Use jog shuttle+SELECT to select the action to be enabled. (You can select
multiple actions.)
8. If you select Save to File in step 7, use the jog shuttle+SELECT to set the file
save format to Binary, ASCII, or Float. If you select Send Mail, use jog
shuttle+SELECT to set Mail Count.
Setting the Number of Actions
9. Press the Sequence soft key to select Single or Continue.
10. If you select Continue, turn the jog shuttle to set the number of actions.
Pressing RESET resets the count to Infinite.
Setting the Execution Mode of the Action-on-Trigger at Power ON
11. Press MENU.
12. Press the Next 1/2 soft key.
13. Press the Others soft key.
14. Press the Action Mode (Power ON) soft key to select ON or OFF.
Executing Action-on-Trigger
15. Press START/STOP. Waveform acquisition is started, and action-on-trigger is
executed. While action-on-trigger is in execution, is displayed at the upper
left of the screen. In addition, if the following action is specified, the following
icon is displayed at the upper left of the screen while the action is being
executed.
Image/Save to File: Save destination medium (
PC card, SCSI device,
internal HD, network drive, or USB storage
device)
Send Mail:
To Next Page
Loading...
