9-6
IM 701240-01E
9.3 Setting the Recording Format of T-Y Waveform
Recording
Procedure
Before carrying out the procedure below, select Chart Recorder mode according to the
procedures in section 9.1.
The settings specified here are not applied to the print settings of the A4 print in Memory
Mode (see page 12-3). However, if you turn OFF the power switch in Recorder Mode,
the settings immediately before the power is turned OFF is stored (see section 3.4).
Therefore, when the power switch is turned ON the next time, the settings in Recorder
Mode that existed immediately before the power was turned OFF are also applied to the
print settings in Memory Mode.
1. Press MENU.
2. Press the RECORD COND soft key.
3. Press the Print Style soft key to select Wave.
4. Press the Print Setup soft key. The print setup dialog box opens.
Selecting the Display (Recording) Format
5. Use jog shuttle+SELECT to select the format.
Setting the Extra Area
6. Use jog shuttle+SELECT to turn the extra area ON or OFF.
Setting the Flexible Zone
7. Use jog shuttle+SELECT to select Setup in Flexible Zone. The flexible zone
setup dialog box appears.
8. Use jog shuttle+SELECT to turn the mode ON or OFF.
9. Use jog shuttle+SELECT to set Upper and Lower of the waveform to be
recorded.
10. Press ESC.
Setting the Graticule
Selecting the Grid
11. Use jog shuttle+SELECT to select the type.
Setting Dark/Light
12. Use jog shuttle+SELECT to select dark or light.
Selecting the Width of the Vertical Scale
13. Use jog shuttle+SELECT to select the width.
To Next Page
Loading...
